What kind of oil 2004 vw jetta

A low oil level will trigger your oil pressure warning light and can cause damage to your engine. We carry the types and weights of oil recommended for your vehicle. Skip to content.

Filter By. High Mileage No 10 Yes 6. Show More Show Less. Compare Compare. Car Check Vehicle Fit. Synthetic Motor Oil 5W; 1 Quart. Oil Composition: Synthetic. Container Size: 1 Quart. High Mileage: No. Conventional or synthetic, In especially hot environments, you may consider using 10W oil. Check for correct part number online or at the parts counter of your local auto parts store. Begin jacking up the front driver's side corner of the car by placing a jack about 5" back from the front wheel cutout on the long vertical part of the frame.

This is the jacking location as stated in the owner's manual. It is helpful, but not necessary, to jack both sides of the car. Since the oil drain plug is located to the passenger side of the vehicle centerline, jacking up just the driver side is sufficient to drain the oil. Raise the corner of the car enough so that you can comfortably work underneath it. Many hydraulic jacks are lowered by placing the open end of the handle over a knob and turning it counterclockwise.

Consult the owner's manual for your jack if you don't know how to lower it. Never work underneath a car that is only supported by a jack.

The jack may slip or fail, resulting in serious injury or death. The oil pan is in front of the front wheels and just to the right of the vehicle centerline. Be sure that the drain pan is positioned so that it will catch the oil when it is streaming out of the oil pan.

Always wear protective gloves and eyewear when working with motor oil. Be careful if your car has been running recently, since the engine and transmission will be very hot. Keep rags or towels nearby to wipe up any spills. After a few full turns with the wrench, use your fingers to loosen the oil drain plug. When the drain plug is completely loose, let it fall into the oil drain pan with the draining oil.

Avoid letting the plug fall if you have an "homemade" pan. However, there is no problem with an oil drain pan off the shelf. Watch the draining oil for shiny specks. Metal flakes in the oil could mean that there is a serious problem with your engine internals. Once the draining has slowed significantly, wipe off the area around the oil drain with a rag or towel. It is better to put a seal under the drain plug outside diameter 20 mm, inside diameter 15 mm. Locate the oil filter on the front side of the engine.

It should be pointing downward and slightly forward. Use an oil filter wrench to loosen the oil filter by turning it counterclockwise about a quarter turn. Loosen the oil filter by hand until oil begins to run down the side of the filter. Once the oil running down the filter has slowed significantly, continue removing it by hand. There will be some oil left inside the filter, so allow it to drain completely while you continue with changing the oil.

Make sure when you add the rest of the oil Step 20 that you take into account the oil added to the filter. There should be 4. Don't worry if a little oil misses the hole; you'll use it to lubricate the filter. Use your finger to apply some of the excess oil evenly around the rubber O-ring. If you didn't spill any oil, dip your finger into the new container of oil instead.

Twist the filter clockwise to screw it into place. Tighten it only until the filter is snug; do not over-tighten. Be sure to use clean gloves to screw in the new filter. Using ones covered in oil will make it extremely hard to grip the filter and could lead to a messy accident.

Only tighten the oil drain plug until it is snug. Over-tightening the oil drain plug can strip the threads or even crack the oil pan—a very costly error.

You can always tighten it more later. Place your jack back in the same location on the frame you used to jack up the car. Raise the jack until it touches the jacking point on the frame.

Use the handle on the jack stand to lower it and remove the jack stand from underneath the car. Be cautious when the car is resting on the jack. It could slip and fall, resulting in serious injury or death if someone is not paying attention.

There should now be a black lever with a red arrow protruding from under the hood. Use one hand to pull the lever straight forward while using the other to lift the hood. Wipe down the area around the filler cap with a rag or towel to remove any oil or debris. The 2. Pour 4. This is 4. Make sure to use 5W oil. Though using slightly different grades will work, it is best to use the type stated in your owner's manual. Remove the funnel and replace the filler cap by turning it a quarter turn clockwise.

You're almost finished! But before you drive away, you should check to make sure you have the right amount of oil.